- Shut off water supply valves then drain lines by turning faucet on.
- Pry off decorative cover and remove screw cap.
- Pull spout assembly off.
- Pull retainer clip from its slot.
- Using pliers, lift cartridge out of body. Note position of cartridge ears so that when replacing, they are in identical position.
- Remove "O" rings by prying away from body and rolling new ones into place, or replace entire cartridge.
- Reverse procedure for reassembly.
- Shut off water supply valves and drain lines by turning faucet on.
- Lift handle up as far as possible and loosen set screw.
- Lift handles off and unscrew cap.
- Loosen screws holding ceramic disc cartridge in body and lift cartridge out.
- On underside of cartridge are the set of seals that should be replaced. Check and clean inlet ports.
- Reassemble by reversing above procedure, being sure cartridge holes align with inlet ports.
|
|
|
